Layer Petal Paper Around a Pink Bouquet

Petal paper can frame a pink bouquet when the visible edges sit below the flowers. Use the video as a layout reference. Make a trial with your own bunch and compare the front and side before tying the layers down.

InnerOuterHandhold

Separate the inner and outer layers

Start with the inner layer, mark its lowest visible point and add one outer layer on the side with the most open space. Rotate the bouquet and check that the edges leave the faces visible and stay clear of the handhold. Record the approved count, order and sheet reference. If the layers bunch up at the grip, shift the overlap and repeat before ordering.

Set a reference at the lowest visible flower

Decide which low flower must stay visible in the presentation photo. Turn the real bouquet towards the customer’s viewing angle and use that flower as the height reference. Place the first piece of petal paper below its face. Check the opposite side after adding an outer piece. Record which edge appears in the front and side photograph.

Change one part of the wrap at a time

Build two trials with the same papers and tie location. In the second, move only the outer overlap to a different side. Choose the position that lets the paper sit comfortably in the hand without covering the lower flower. Then put both trials in the actual holder for the order and see whether the paper edge rubs the rim or rises into the flower head when lifted out.

Check the sheet requirement before confirming quantity

Keep the paper code and count by layer, the tie mark, a photo of the front and side, and the approved overlap position. Repeat with a second bunch of the same recipe, then test the widest bunch if the order uses mixed sizes. If the wider bunch needs a different outer layer, count it separately. Confirm order quantity in the actual sales unit and check availability to the destination and freight separately.

Watch the petal-paper layers · Matte-paper folding guide

Leave a Reply

Your email address will not be published. Required fields are marked *