How to Wrap a Bouquet With Two Sheets of Cardstock

Last updated:

Make the two cardstock pieces identifiable

Before cutting the batch, mark piece A and B on the back of the accepted sample, including outward face and fold direction. Have another worker rebuild it from those marks. If the outline reverses, compare face and orientation before changing dimensions.

Keep the two references as a complete cutting set. Count loose A pieces and loose B pieces separately; neither is a finished wrap. Re-test a substitute sheet on the actual bouquet rather than assuming equal thickness from appearance.

Discuss this sample

Use the first sheet to hold the stems and the second to frame the flowers. Trial the two layers on a finished bouquet before using the method for a full order.

Fit the inner and outer sheets

  1. Lay the first sheet around the stems with the join at the back. Keep enough room to lift the bouquet at the binding point.
  2. Dry-fit the second sheet so the upper edges frame the flowers and the lower edge clears your hand.
  3. Bind at the stem area, then place the finished bouquet in its actual carrier. Check that the paper points and petals clear the lid.
Two-sheet wrapping demonstration by 拂苏花艺课程. Watch on Instagram · Original post on Xiaohongshu.

Adjust a fold that whitens or springs open

Compare a rounded fold and a firm crease on offcuts from the same sheet. If the crease whitens, move it behind the stems or soften the bend. If the outer layer springs open, reduce excess overlap at the tie and test the grip again. Record which crease stays presentable after you lift and set down the bouquet.

Calculate how many packs to order

Record the approved inner and outer sheet references separately. For example, 30 bouquets using one inner sheet and one outer sheet each need 30 of each. If you can use 18 inner sheets and 20 outer sheets per pack, order two packs of each before allowing for any additional samples.

Compare wrapping paper samples · See the single-sheet fold guide · Request a wholesale quote

Leave a Reply

Your email address will not be published. Required fields are marked *